When you own a business, you don’t want to be faced with a broken garage door. You can easily prevent this from happening with a few simple fixes. These tips will help keep your commercial garage doors running for as long as possible.
Replace broken torsion springs
If your commercial garage door springs are breaking, you’ll have to replace them. But before buying replacement springs, ensure you know what to expect. Read the instructions for replacing your torsion springs. Then, ask if the price includes labor. If not, it may be a scam.
You can purchase replacement torsion springs at any hardware store. They cost $20 to $90, depending on the type. You will need two winding bars to put proper tension on the new springs. You should also have an eight-point socket and vise grips. The tool is important because it helps prevent the torsion shaft from falling out.
It would help if you also considered buying double-life springs. These springs have a longer life, 25,000 cycles. You can get a cheaper, standard spring if you want to spend less money.
You should also measure the diameter of the wire in the coils. You can do this by using a wire gauge and measuring ten coils. After you’ve made this measurement, you should convert it to a decimal.
Replace misaligned metal tracks
There are several reasons why a commercial garage door can be misaligned. Sometimes, the problem is caused by a broken torsion spring or a bent track. It could be a faulty drum connection or a decayed jamb in other situations.
The tracks on a garage door are important because they guide the door’s movement. They are also fragile and can be easily bent. As a result, misaligned tracks can cause problems with the door’s operation.
A professional garage door repair Pembroke Pines can repair damaged garage door tracks. It’s recommended that you call a company specializing in overhead doors if you have a problem. They can inspect the track, clean it, and make necessary adjustments.
A misaligned garage door can make it difficult to open or close. The problem may be caused by a bent track or something caught in grooves. The tracks should be even in height and width. If the tracks are aligned properly, the rollers can move smoothly along the track.
Replace the motor
If your garage door opener doesn’t work, it’s time to replace the motor. This is usually a DIY project. You can always contact an expert if you’re uncomfortable with the process.
First, disconnect the power supply from the motor. This will allow you to see if the wiring is connected to the motor or the wall control panel. You can reconnect the wires to the old cables or connect them to the new wires.
Next, remove the header bracket and the clevis pin. You may also need to loosen the rail. You can do this with a step ladder, but you must close the door before you begin.
Once the trolley is removed, you can take the chain unit out. Be sure to clean the chain carefully, and you will need to apply lubricant. You will also need to take your time.
Now, disconnect the RPM sensor and safety sensor wires. These can be found on the motor unit. You may need to use a flat-tip screwdriver to release them.
Now you know all the steps to remove, inspect and re-install your garage door opener. But before you start the job, be sure to disconnect the power from the circuit breaker box. This is an important safety measure.
Also, if you need more confidence in your ability to do this project, hiring a professional garage door repair Pembroke Pines for help is a good idea. Having a professional install or repair your garage door opener can help to ensure that it is done correctly and safely.
Finally, test the door with the remote control before putting everything back together. This will allow you to make sure that everything is working properly.